Hackle Stacker

Hackle Stacker, PMD

Show

Tying Instructions

1. Attach the thread to the hook shank and lay a thread foundation to the bend of the hook. At that position create a small bump of thread.

2. Clip 4-5 microfibbetts, keep the tips even. Measure the tailing material to be equal to the shank length of the hook. Position the material just behind the thread bump against the shank in front of you. A thread wrap will bring the material to the top of the shank and you can wrap the excess material to the top of the shank until you reach the 70% mark of the hook shank.

3. Wrap the thread back to the tail tie-in position and put your thumb under the microfibbetts behind the thread bump. Another firm thread wrap over the tailing material will splay the microfibbetts from the tension put on them against the thread bump.

4. Apply a small amount of dubbing to the thread and secure the fibers to the shank with one wrap. You can increase the firmness of the dubbing by twisting the material on the thread once it’s anchored to the hook shank.

5. Wrap the dubbing forward to the 70% position for a tapered body.

6. Cut a piece of 3″ nylon thread and match up the ends of the piece. Anchor the ends just behind the eye of the hook and secure the nylon thread down to the 70% position.

7. Build a thread base on the nylon thread loop. I find that rotating the loop towards you will help. Hold the loop with one hand as you move the thread bobbin around it with your other hand. I’ll switch hands to facilitate the movement, but always keeping tension of the loop.

8. Obtain a hackle sized to the hook. Clean the butt fibers of the hackle off so that enough bare quill is available to anchor the hackle to the shank at the base of the nylon loop post and enough bare quill to anchor up the post about 1/3 the shank length. Again, having the loop facing you horizontally, will assist you in anchoring the quill to the base of the post. Make sure to keep the tension on the loop to maintain control.

9. Attach hackle pliers to the end of the hackle and wrap the hackle down the post about 6-7 wraps. Again, keeping the loop horizontal, toward you….I find this method easier to hold the loop and control the wrapping of the hackle pliers. The last wrap will go over the hook shank at the base of the post and you secure the hackle with a couple of thread wraps. Now rotate the fly back into the upright position.

10. Clip of the excess hackle material and snip out any errant fibers. Pull the wrapped hackles back with your left hand and secure the last hackle wrapped at the base of the post with a few more thread wraps. Apply the thorax dubbing with a tight mound just in front of the hackle post. The thorax should be about twice the diameter as the abdomen.

11. Bring the nylon loop over the dubbed thorax, securing the nylon just behind the eye. The hackles should be positioned on top of the dubbed thorax.

12. Bring the nylon loop back towards the tail and add a number of additional wraps to secure the nylon thread. Whip Finish.

13. Trim of the excess nylon thread..

Materials to Order Material, click the link
Hook	TMC 100 #16-20
Thread	Uni-thread Light Cahill 8/0
Body	Pale Yellow Superfine Dubbing
Thorax	PMD Superfine Dubbing
Tail	Light Dun Microfibbetts
Post	6X tippet
Hackle	Ginger Hackle

Bob Quigley

Hackle Stacker

The Hackle Stacker is a mayfly emerger pattern. It utilizes a paraloop method of wrapping hackles around a looped monofilament and bringing the monofilament over a dubbed thorax to a tie-off location just behind the eye. The result is a group of hackles residing upon the top of the thorax keeping the hackles well above the hook shank. This allows the fly to submerge itself well into the surface film and results in better hook-ups due to the hook placement being lower in the water.

The late Bob Quigley is often cited as the developer of this fly although the technique can also be attributed to the late Jim Cramer of Bodega Bay, CA and the late Ned Long of Tahoe City, CA, who used it as well. Ned received the Buz Buzsek award in 1996 and mentioned that the “pullover” technique was not his invention either but he improved on the technique. Often, many will fish this pattern behind a hi-vis dun using the dun as an indicator. Rather than utilizing a material such as 7X monofilament as the hackle post, other materials can be used such as Z-lon, Poly Yarn, Floss, and thread. The stiffer materials can be used as a wing post without a gallows tool.

Variations

Quigley’s choice of materials for tailing was often some fibers of z-lon or microfibbetts. The body can be Superfine dubbing, Turkey Biots, or Dyed Quill. Bob developed a few variations from this pattern. One is the Hackle Stacker Flag Dun which incorporates a section of z-lon for the wingpost and wing. This can be very helpful in sighting the fly.

Another variation is his Sparkle Stacker, which uses thread or floss for the body, poly yarn for the wing, and z-lon as tailing material. Bob combined the two and came up with the Sparkle Flag which utilizes a Z-lon tail and a thread body for smaller patterns such as PMD’s in sizes 18-22. The hackle is wrapped around the Z-lon wing post and once pulled over the dubbed thorax, it serves as a wing. The “flag” not only serves as a wing but also allows you to sight the pattern more easily. The Loopy Cripple Stacker is another variation as well using poly yarn as the wing and looping the material over the hackles.

Hackle Stacker-Callibaetis

Hook	TMC 100 #14-16
Thread	Uni-thread Gray 8/0
Body	Gray Turkey Biot
Thorax	Callibaetis Superfine
Tail	Grizzly Spade Hackle Fibers
Post	6X tippet
Hackle	Grizzly Hackle

Hackle Stacker-BWO

Hook	TMC 100 #16-22
Thread	Uni-thread Olive 8/0
Body	BWO Superfine Dubbing
Thorax	BWO Superfine Dubbing
Tail	Light Dun Microfibbetts
Post	6X tippet
Hackle	Med. Blue Dun Hackle

Hackle Stacker-Female Baetis

Hook	TMC 100 #16-22
Thread	Uni-thread Olive 8/0
Egg Sac	Black Superfine
Body	Olive Dyed Quill
Thorax	BWO Superfine Dubbing
Tail	Light Dun Microfibbetts
Post	6X tippet
Hackle	Dark Blue Dun Hackle

Hackle Stacker Flag Dun-PMD

Hook	TMC 100 #16-20
Thread	Uni-thread Light Cahill 8/0
Body	Turkey Biot, PMD
Thorax	PMD Superfine
Tail	Dark Dun Microfibbetts
Wingpost	Cream Z-lon
Hackle	Ginger Hackle

Sparkle Flag Dun-PMD

Hook	TMC 100 #18-22
Thread	Uni-thread Yellow 8/0
Body	Uni-thread Yellow 8/0
Thorax	PMD Superfine
Shuck	Z-Lon ,Olive Brown
Wing	Cream Z-lon
Hackle	Light Ginger Hackle

Sparkle Stacker (BWO)

Hook	TMC 100 #20-22
Thread	Uni-thread Olive 8/0
Body	Uni-thread Olive 8/0
Thorax	BWO Superfine
Shuck	Z-Lon, Olive Brown
Post	White Antron Yarn
Hackle	Dun Hackle

Loopy Cripple-PMD

Hook	TMC 2487 #14-20
Thread	Uni-thread Light Olive 8/0
Body	Pheasant Tail
Thorax	PMD Superfine
Ribbing	Copper Small Wire
Tail	Pheasant Tail
Wing	Light Gray Poly Yarn
Hackle	Light Ginger Hackle